beautypg.com

Intermec PB50 User Manual

Page 40

background image

Chapter 2 — Configuring the PB50

30

PB50 Mobile Label and Receipt Printer User’s Guide

4

From the host PC, check the wireless settings.

If you have an IPL version of the printer, send these commands to
the PB50:

wt,SSID

wt,WEP1

wt,WEP2

wt,WEP3

wt,WEP4

wt,AUTH

wt,WPA

wt,WPA2

wt,WPA_PSK

wt,ROAM

wt,PWR_MODE

wt,CHANNEL

wt,AP_MAC

wt,SIGNAL

wt,SPEED

wt,ACTIVE

If you have a Fingerprint version of the printer, send this
command to the PB50:

setup write "wlan","uart1:"

5

Set up the PB50 to use the correct SSID and authentication
modes. See one of the following procedures to configure wireless
printing on your IPL or Fingerprint printer.

6

If you are going to use certificates for validation, transfer the
certificate to the printer. The printer can accept .pfx, .pem, and
.der certificates.

7

Verify that the PB50 is connected to the access point and make
sure it has an IP address allocated to it.

Understanding the 802.11 Radio Icons

Icon

Description

Excellent signal

Strong signal

Good signal