ITT SMART SWITCH 801P5 - Manual (Page 26)

Page 22 Installation and Operation Manual
NOTE
To change the (r-Lo)and (r-Hi):
1. Press the [MENU] key and use the [UP/DOWN ARROW]
keys to move through the menu selections to r-Lo.
2. Press [SELECT]. The furthest right digit will blink.
3. Change the digit’s value with the [UP/DOWN ARROW] keys.
4. When the value is correct, press the [SELECT] key to move to
the next digit and repeat step 3. Repeat for each digit until
you have the correct value for r-Lo.
5. Use the [STORE] key to temporarily save the changes and
return to the main menu.
6. Press [RUN]and then [SELECT] to permanently save the
setting and return to On-Line operation.
7. Repeat steps 1 through 6 for r-Hi. The setting should be at
least 2 display counts higher than r-Lo.
Decimal Location (.Loc)
You can change the location of the decimal point, thereby
changing the scale of the display, by using this function.
After .Loc displays, press [SELECT] to move the location
one digit left. When the correct location has been reached,
press [STORE] to temporarily save your setting.
When the decimal point is in the far right location, no decimal is
displayed during operation.