InFocus LP 250 User Manual

Page 35

WARNING

: To avoid burns, allow the projector to cool for at least 60 min-

utes before you replace the lamp.
WARNING

: Do not drop the lamp module or touch the glass bulb! The

glass may shatter and cause injury.
WARNING

: Be extremely careful when removing the lamp housing. In the

unlikely event that the bulb ruptures, small glass fragments may be gener-
ated. The lamp module is designed to contain these fragments, but use cau-
tion when removing the lamp module.

Carefully remove the lamp housing. Dispose of the lamp in an environ-
mentally proper manner.

Install the new lamp housing and tighten the screws.

Replace the lamp door.

Plug in the power cord, press the Power button to turn the projector
back on.

To reset the lamp hour timer, navigate to the Settings>Service menu
and select Reset Lamp. Or, press the Volume + button then the Volume -
button.

Reset Lamp

p5p7 manual.fm Page 35 Thursday, January 9, 2003 9:46 AM

This manual is related to the following products:

LP 240