iHome IP43 User Manual

Page 9

Using the iP43 Alarms

Listening to iPhone/iPod, Radio

Charging your iPhone/Pod

Note: Please make sure you are using the correct insert for your iPhone/iPod and that it is properly docked into the iP43.

Failure to do so may damage your iPhone/iPod.

While an iPhone/iPod is docked in the unit and the unit is connected to AC power, it recharges until fully charged.

Listening to iPhone/iPod

1. Dock an already-playing iPhone/iPod in the dock. The iP43 will automatically turn on and you will hear the audio playing

from your iPhone/iPod.

Note: If the playing song/music loudness is too low on the iPod itself, the iP43 may not detect iPod is in play mode. Press

the

Button to play it.

2. When an iPhone/iPod is docked and in standby mode, press the

Button to play it. “iPod” will appear briefly in the lower

part of the display to show iPod is currently in play mode.

3. Press the

Button again to pause play; press again to resume it.

4. Turn the

Volume Wheel to adjust the system volume.

5. Press the

EQ Button to select and turn the Set Wheel to adjust Treble, Bass, and Left/Right Balance.

6. To turn off the unit, press the

Button. An iPhone/iPod will continue charging while docked.

Listening to FM Radio

Setting up the Antenna

Extend FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the Radio

1. Press the

Radio Button to turn on the iP43.

2. Turn the

Set Wheel to tune the radio to a desired FM station. The current radio frequency appears in the lower part of the

display.

3. Turn the

Volume Wheel to adjust the system volume.

4. Press the

EQ Button to select and turn the Set Wheel to adjust Treble, Bass, and Left/Right Balance.

5. To turn off the unit, press the

Button.

Resetting the Alarm to Come on the Next Day

When an alarm is sounding, press the

Button to stop the alarm and reset it to come on the next set day. For example, if

an alarm is set for 5 days and you press the alarm reset on Friday, the alarm will come on again on Monday, not Saturday.

Snooze Operation

1. Press and hold the

Snooze/Dimmer Button for a few seconds until the snooze time flashes. Turn the Set Wheel to set

the snooze timer from 1 to 29 minutes.

2. Press the

Snooze/Dimmer Button on the unit (or the Snooze Button on the pillow shaker if it is ON) after an alarm

sounds. The alarm will be silenced for the set snooze duration time then sound again. Snooze can be pressed several times

during the 1 hour alarm cycle.

Sure Alarm

The iP43 has a sure alarm feature. If backup batteries are installed, the buzzer alarm will still sound in the event of a power

failure.