Insignia NS-4111TU - Manual

Read these instructions carefully before using this product, and retain
them in a safe place for reference.
Features
Top
1 Handle 5 Function (RADIO/CD/AUX)
2 CD door 6 Power (ON/OFF)
3 Volume control 7 Tuning control
4 FM antenna 8 CD door open (push tab)
Back
1.5V x 8 UM 2 or
“C” size or LR14
+ - + -
+ - + -
+ - + -
+ - + -
1 AUX IN jack
2 Battery compartment
3 Headphone jack
4 AC input
Quick Installation Guide
NS-B4111/NS-B4111TA/NS-4111B/NS-4111G/NS-4111TU CD Boombox
Front
1 Speaker 8 Speaker
2 Light button 9 CD skip down
3 AM/FM button 10 CD skip up
4 Random button 11 CD search down button
5 CD track display 12 CD search up button
6 Repeat button 13 CD play/pause button
7 CD stop
Setting up your CD player
Connecting AC power
1 Connect the provided AC power cord to the AC input socket
on the CD player.
2 Plug the cord into a household AC power socket.
Installing batteries
1 Insert eight C alkaline batteries (not included) into the
battery compartment as indicated by the diagram within
the
compartment.
2 Securely close the battery compartment cover.
Notes: Battery power is used only when AC power is
disconnected.
Replace all batteries at the same time with the same battery
type. Do not mix battery types.
When CD player is stored unused for a long time, remove the
batteries to prevent damage.
Using your CD player
Warning: Use of any controls, adjustments, or procedures
other than those specifi ed herein may result in hazardous
radiation exposure.
Using the radio
1 Slide the FUNCTION selector to RADIO, then press AM/FM
to select AM or FM mode.
2 Turn the TUNING control until you locate the station you want.
If you tune to an FM station broadcasting in stereo, the
stereo indicator turns on. “ST” will appear in the upper-right
of the LCD screen when stereo is on.
• For optimum FM reception, make sure that the FM
(telescopic) antenna is fully extended and vertical.
• For optimum AM reception, rotate the CD player to orient
its built-in antenna until you get the strongest signal.
Using the CD player
The CD player can play standard audio CDs and audio CDs
created on a computer’s CD-R/CD-RW drive.
1 Slide the FUNCTION selector to CD, then lift the CD door
and insert a CD with the label facing up. Make sure that the
CD is correctly mounted on the spindle and locked in place.
2 Close the CD door. After a few seconds, the display shows
the total number of tracks on the CD. If the disc is not
correctly inserted or defective, the display shows .
To play the CD Press PLAY/PAUSE. The current track number is
shown on the display.
To pause
playback Press PLAY/PAUSE. The play indicator flashes on the
display. Press PLAY/PAUSE again to resume playback.
To stop playback Press STOP. The display shows the total number of
tracks on the CD.
To skip tracks Press or .
To repeat the
current track Press REPEAT. To repeat the entire disc (continuous
play), press REPEAT twice. To return to normal
play, press REPEAT until “REPEAT” disappears from
the display.
To play tracks in
random order Press STOP, press RANDOM, then press PLAY/PAUSE.
To stop random playback, press RANDOM again.