Assembly – Image IMTL07800 User Manual

Page 5

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench ,
and your own adjustable wrench .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.

2. Finger tighten an Upright Bolt (7) into the lower end of the

right handrail.

Next, hold an Upright Spacer (11) inside the lower end of
the right Upright (80). Insert an Upright Bolt (7) through
the Upright and the Upright Spacer. Reach under the
treadmill and finger tighten a Nut (12) onto the Upright Bolt.

Repeat this step on the left side of the treadmill (not
shown).

Tighten all three Upright Bolts (7) on each side of the
treadmill.

1. With the help of a second person, carefully raise the

Uprights (80) until the treadmill is in the position shown.
Note: Be careful not to damage the Hood (85) with the
handrails as you raise the Uprights.

Handrail

3. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a

secure place. The allen wrench is used to adjust the walking belt (see pages 12 and 13). To protect the floor
or carpet from damage, place a mat under the treadmill.