Connecting a serial ata hard disk drive, Connecting a parallel ata hard disk drive, Removing and replacing memory – IBM THINKCENTRE 8141 User Manual
Page 21: Connecting, Serial, Hard, Disk, Drive, Parallel, Removing
5.
Note
the
orientation
of
the
hard
disk
drive
in
the
plastic
bracket.
6.
Remove
the
drive
by
flexing
the
plastic
enough
to
slide
the
drive
out.
7.
Install
the
hard
disk
drive
into
the
plastic
bracket
by
flexing
the
plastic
enough
to
slide
the
drive
in.
8.
Install
the
hard
disk
drive
and
bracket
into
the
bay
until
it
snaps
into
position.
9.
Depending
on
the
type
of
drive
you
are
installing,
go
to
or
Connecting
a
serial
ATA
hard
disk
drive
A
serial
hard
disk
drive
can
be
connected
to
any
available
SATA
connector.
1.
Locate
the
signal
cable
that
comes
with
the
new
drive.
2.
Locate
an
available
SATA
connector
on
the
system
board.
See
3.
Connect
one
end
of
the
signal
cable
to
the
drive
and
the
other
to
an
available
SATA
connector
on
the
system
board.
4.
Connect
a
power
connector
to
the
drive.
5.
To
complete
the
installation,
go
to
Connecting
a
parallel
ATA
hard
disk
drive
1.
Locate
the
PATA
IDE
connector
on
the
system
board
and
the
three-connector
signal
cable.
2.
Connect
one
end
of
the
signal
cable
to
the
drive
and
the
other
to
the
PATA
IDE
connector
on
the
system
board.
See
3.
Connect
a
power
connector
to
the
drive.
4.
To
complete
the
installation,
go
to
Removing
and
replacing
memory
Attention
Do
not
open
your
computer
or
attempt
any
repair
before
reading
the
“Important
safety
information”
in
the
Quick
Reference
that
was
included
with
your
computer.
If
you
no
longer
have
this
copy
of
the
Quick
Reference
,
you
can
obtain
one
online
from
the
IBM
Web
site
at
http://www.ibm.com/pc/support.
This
section
provides
instructions
on
how
to
remove
and
replace
memory.
1.
Remove
the
cover.
See
Replacing
customer
replaceable
units
(CRUs)
13