Image IMHS40090 - Manual (Page 12)

12
Console Diagram
USING THE CONSOLE
Refer to the console diagram above. The function of
each console control is explained below:
Air Control: Determines the amount of air that is in
the spa jet system during operation. If the control is
turned to the left, the amount of air flowing through
the jets will increase. If the control is turned to the
right, the amount will decrease.
On/Off Button: Turns the spa on and off. When you
first press the on/off button, the spa jet unit will run at
low speed, providing gentle hydrotherapy. Press the
button again and the spa will run at high speed, pro-
viding more intense hydrotherapy. Press the button a
third time, and the spa will shut off.
The spa also features an automatic mode which heats
and filters the water when the spa is left unattended.
When the spa is first plugged in, or if the buttons on
the console have not been used for longer than twen-
ty minutes, the automatic mode will begin filtering or
heating the water, as needed. Note: To keep the fil-
ter and heat cycles from running, the power cord
must be unplugged.
Thermostat: Controls the temperature of the water.
The water heats at about 1.8¡F an hour with the cover
on. The thermostat can be set to heat the water from
70¡F to 104¡F. You should use a medical or other
accurate thermometer to check the temperature of the
water.
Thermostat
On/Off Button
Air Control