IFoundry Systems IFSYS-8003 - Manual (Page 19)

Page 19 of 50 Copyright © 2002 iFoundry Systems
IFSYS-8003 IrDA FIR USB Adapter User Guide
•
When copying has been completed, Windows will be returned to the desktop, with
no further apparent installation activity. Your system must be restarted at this
point for proper functioning of the Infrared capability that Windows has just
installed.
•
Restart the system, keeping the IFSYS-8003 adapter connected to the USB port
on your PC.
•
When the Windows desktop re-appears once again, Windows will detect the
IFSYS-8003 adapter, load the appropriate driver as well as the “IR Monitor”
software that will be used to communicate with other infrared enabled devices.
•
You should be able to observe the following activity:
•
LED on the IFSYS-8003 adapter flashes every few seconds (this “discovery”
process allows a nearby infrared device to be sensed),
•
You should see the infrared icon on your windows system tray (located on
the bottom right hand corner of the Windows desktop). In this instance, the
icon is shown to the left of the displayed time.
•
At this point, the IFSYS-8003 adapter will have been fully configured for use.
•
You may additionally need to install software provided by your device
manufacturer.