Magellan MG-6160 - Manual (Page 7)

Magellan - X10 Operation User Guide 6
X10 Activation/Deactivation on Remote Button
Magellan’s X10 outputs can be programmed to activate or deactivate when a button on your remote
control is pressed. To configure the X10 outputs to do so:
1. Access the X10 Setup menu (see “Accessing the X10 Setup Menu” on page 2).
2. Press the center [ ACTION ] key (next) twice and then press the left [ ACTION ] key (ok) to program
Magellan’s X10 Remote Button feature.
3. Press the left [ ACTION ] key (ok) to program button 1 on your remote control to activate or deactivate
an X10 output.
4. Configure the X10 outputs you wish to activate or deactivate with the Remote Button option and then
press the right [ ACTION ] key (exit). See “Enabling/Disabling the X10 Outputs” on page 2 for more
information.
5. Press the left [ ACTION ] key (ok) to program button 2 on your remote control to activate or deactivate
an X10 output.
6. Configure the X10 outputs you wish to activate or deactivate with the Remote Button option and then
press the right [ ACTION ] key (exit). See “Enabling/Disabling the X10 Outputs” on page 2 for more
information.
X10 Activation/Deactivation on Exit Delay
You can program Magellan’s X10 outputs to activate or deactivate during the Exit Delay timer of your
system. To do so:
1. Access the X10 Setup menu (see “Accessing the X10 Setup Menu” on page 2).
2. Press the center [ ACTION ] key (next) three times and then press the left [ ACTION ] key (ok) to program
Magellan’s X10 On Exit Delay feature.
3. Configure the X10 outputs you wish to activate or deactivate whenever your Magellan system
initiates the Exit Delay timer and then press the right [ ACTION ] key (exit). See “Enabling/Disabling the
X10 Outputs” on page 2 for more information.
X10 Activation/Deactivation when System Armed
Use this option to activate or deactivate Magellan’s X10 outputs when your system is armed. To do so:
1. Access the X10 Setup menu (see “Accessing the X10 Setup Menu” on page 2).
2. Press the center [ ACTION ] key (next) four times and then press the left [ ACTION ] key (ok) to program
Magellan’s X10 When Armed feature.
3. Configure the X10 outputs you wish to activate or deactivate whenever your Magellan system is
armed and then press the right [ ACTION ] key (exit). See “Enabling/Disabling the X10 Outputs” on
page 2 for more information.
X10 Activation/Deactivation on Entry Delay
The X10 outputs can be programmed to activate or deactivate whenever either or both of Magellan’s
Entry Delay timers are initiated. To do so:
1. Access the X10 Setup menu (see “Accessing the X10 Setup Menu” on page 2).
2. Press the center [ ACTION ] key (next) five times and then press the left [ ACTION ] key (ok) to program
Magellan’s X10 On Entry Delay feature.