Operating instructions (continued) – Memorex MX3720 User Manual
Page 8
7
OPERATING INSTRUCTIONS (CONTINUED)
MUTE
To temporarily mute the sound, press the MUTE button on the
remote control; “MUTE” will appear in the display and the sound will
be muted. Press the MUTE button again to restore the sound and
“MUTE” will disappear from the display.
1
Press the POWER button to turn
the unit on; the STANDBY
indicator will go out.
1
Press the
Tuning/CD SKIP/Search
❶
or
❷
button to select a
station (see Tuning note below).
NOTE: If the FM band is selected
and you have tuned to an FM Stereo
station, the FM Stereo indicator will
light in the display.
1
2
4
Slide the FM MODE switch on the
rear of the unit to the ST or
MONO position to select Stereo
or mono when listening to an FM
station.
3
Press the TUNER Function button
❶
; “TUNER” will appear in the
display. Press the BAND/
STOP(■) button❷ to select AM or
FM.
2
1
2
Adjust the PRESET EQ ❶ and
VOLUME ❷ buttons as desired.
2
1
5
When you have finished listening,
press the POWER button to turn
the unit off; the STANDBY
indicator will light.
6
Hints for Better Reception:
FM - Make sure that the FM Wire Antenna is extended to its full length. You may have to vary the direction
of the antenna to find the strongest signal for each FM station.
AM - The AM ferrite bar antenna is located inside the unit. It may be necessary to turn the unit slightly so
that the internal antenna is pointing in the direction of the AM transmitter. You may have to experiment to
find the position that provides the strongest reception for each of your favorite AM stations.
LISTENING TO THE RADIO
TUNING:
MANUAL TUNING: Repeatedly press the Tuning/CD SKIP/ Search
or
to manually advance the
frequency in the display up or down until the desired frequency appears.
AUTOMATIC TUNING: Press and hold the Tuning/CD SKIP/ Search
or
until the frequency in the
display starts to scan, and then release the button; the tuner will search and then stop on the next strong
station it finds. Repeat this procedure until the desired frequency appears in the display.
MX3720.O/M.QXD 4/30/02 10:48 AM Page 7