Miller Electric S-22P12 User Manual
Page 17
OM-181 931 Page 13
3-7.
Connecting Weld Cable And Installing Drive Rolls
ST-801 128-B / ST-162 079-A / Ref. S-180 967
1
Weld Cable From Welding
Power Source
Route weld cable from power
source through rear panel and con-
nect to terminal on drive assembly.
Install and secure wire guide. Install
drive rolls and turn drive roll nut one
click.
Only drive gear is adjustable. Turn
adjustment screw in or out until
groove in drive roll lines up with wire
guide as shown.
Remove drive rolls, and clean
grooves using a wire brush.
2
Rating Label Location
Tools Needed:
3/16 in
7/16, 9/16 in
1
Installation
Alignment
2
See also other documents in the category Miller Electric Tools:
- OM-2241 (32 pages)
- ICE-27C (36 pages)
- Arc Welding Power Source (4 pages)
- INVISION 456 CC (44 pages)
- Welder (132 pages)
- SS-75D12 (44 pages)
- Load Bank LBP-350 (2 pages)
- OM-193 084E (36 pages)
- 750MPa (2 pages)
- APT-1000 (20 pages)
- OM-220 390F (48 pages)
- 271 (48 pages)
- Welding (32 pages)
- DC (72 pages)
- OM-129 (70 pages)
- XLi (24 pages)
- S-64 (36 pages)
- ICE-27T (36 pages)
- PipePro 304 (76 pages)
- AA40GBU (28 pages)
- D-64 (40 pages)
- Auto Arc XLT 165 (48 pages)
- 185 DX (56 pages)
- S-32S (4 pages)
- Big 40 DC/TIG 55500 A (8 pages)
- Big Blue 600D (60 pages)
- Millermatic 140 (60 pages)
- pmn (36 pages)
- LMSW Series (2 pages)
- 1250 (46 pages)
- Trailblazer Pro 350 D (8 pages)
- TS (76 pages)
- 602 (40 pages)
- Axcess 300 (56 pages)
- MOG-400 (40 pages)
- WC-24 (20 pages)
- Big Blue 502P (64 pages)
- Dimension 1000 (44 pages)
- DS-74DX12 (52 pages)
- 350 VS (36 pages)
- 24A (32 pages)
- GA-16C (12 pages)
- Big Blue 502D (116 pages)
- OM-229 038D (36 pages)