Melissa 640-089 - Manual (Page 15)

ASSEMBLING THE VACUUM
CLEANER
Always remove the plug from the power
socket before fitting or removing
accessories.
Adjustment of the telescopic tube:
You can adjust the lenght of the telescopic
tube by holding the black ring and pulling or
pushing the part with the locking mecanism.
It can be unlocked just as easily and
brought into a different position.
Fitting the tube:
Insert the tube into the air intake on the top
of the appliance. Insert the tube and press
until it clicks into position
Removing the tube:
Remove the plug from the power socket.
To release the tube, press the button on the
end of the tube and pull the tube firmly
from the air intake duct.
FLOOR BRUSH USE
- Press the button on the floor brush to
the position with brushes for cleaning
hard floors.
- Press the button on the floor brush to
the position without brushes for
cleaning carpets.
REMOVING THE ACCESORIES
- To remove the accessories, pull the
accessory firmly off the tube.
INSTRUCTIONS FOR USE
- Before using the appliance unwind a
sufficient length of cable and insert the
plug into the power socket. A YELLOW
mark on the power cable shows the
ideal cable length. Do not extend the
cable beyond the RED mark. To rewind
the power cable, press the rewind
button with one hand, and guide the
cable with the other hand to ensure
that it does not whip causing damage.
- Press the ON/OFF button to switch on
the appliance.
USING THE CLEANING
ACCESSORIES
1. The dusting brush
for furniture, venetian blinds, books,
lamp shades and shelves.
2. The crevice tool
for radiators, crevices, corners,
baseboards and between cushions.
3. The upholstery brush
for cushions and drapes.
REPLACING THE DUSTBAG
- After removing the tube, open the front
cover by pressing the button and
pulling upwards.
- Remove the dustbag.
- Replace the dustbag as described
below:
- Insert a new filterbag by leading the
cardboard on the filterbag into the
drills of the filterholder.
- Close the front cover by pressing it
down until it clicks.
REPLACING THE HEPA FILTER
The HEPA filter is the filter placed on the
back of the vacuum cleaner:
Press the release-button on the grid and
pull it out at the same time.
Remove the HEPA filter and insert a new
HEPA filter.Insert the grid back in place.
REPLACING THE MOTORFILTER
The motorfilter is the filter placed behind
the dustbag:
Open the front cover and gently pull the
filter free of the holders. Insert a new
motorfilter.
15
SMC85_IM 22/12/04 14:21 Side 15