McIntosh C2200 - Manual (Page 8)

8
Rear Panel Connections
Connect the
power cord to a
live AC outlet.
Refer to informa-
tion on the back
panel of the
C2200 to deter-
mine the correct
voltage
Main Fuse holder,
refer to information
on the back panel of
the C2200 to deter-
mine the correct
fuse size and rating
The EXTernal
SENSOR Jack
permits the con-
nection of a
McIntosh IR Sen-
sor for remote
operation
DATA PORTS send
control signals to
compatible source
components and allow
Remote Control op-
eration PASS THRU Power
Control input receives
a Turn-On signal
from a McIntosh
Home Theater Con-
troller
POWER CONTROL/TRIG-
GERS Outputs send Turn-On
signals to other components
connected to the C2200. The
MAIN Jack sends the signal
when the C2200 is switched
On. The 1 and 2 Jacks send
the signal when the OUT-
PUTS 1 and 2 Push-buttons
are active. The ACCessory
Jack is for sending the signal
to McIntosh Source Compo-
nents. The SETUP Feature in
the C2200 allows the ACC, 1
and 2 Power Control Jacks to
be re-assigned to Switch On
when the desired Input Source
is selected.
TAPE/REC OUT-
PUTS contain
RECord Out Signals Unbalanced MAIN OUT-
PUTS contain the program
signals at all times. The Un-
balanced 1 and 2 OUTPUTS
contain the program signals
and turn On/Off with the
Front Panel OUTPUTS 1 and
2 Push-buttons
TAPE/REC, VCR, SAT, DVD,
CD, CD2 and TUNER unbal-
anced INPUTS accept high
level program source signals
PH/AUX accepts high
level program source sig-
nals or signals from a
Moving Magnet Phono
Cartridge. The SETUP
feature determines
whether the Input Jacks
are set for AUX or
PHONO
Gound connection
for turntables Balanced MAIN OUTPUTS
contain the program signals
at all times. The Balanced 1
and 2 OUTPUTS and can be
switched On/Off with the
Front Panel OUTPUTS 1 and
2 Push-buttons
VCR, SAT, DVD and CD Bal-
anced INPUTS accept high
level program source signals