How to mount a remote nfs server, Dynamic driver module load/unload, How to mount a remote nfs server -9 – Moxa Technologies EM-1240-LX User Manual
Page 42: Dynamic driver module load/unload -9
EM-1240-LX User’s Manual
Configuring EM-1240-LX
4-9
To check if PPPOE is successfully connected, use the command:
y
/>ifconfig ppp0
How to Mount a Remote NFS Server
Currently, the EM-1240-LX only supports NFS (Network File System) clients. Users can open
NFS service on a Linux PC to enable the EM-1240-LX to push data to it. The EM-1240-LX can
use NFS to mount a remote disk as a local disk for data or log purposes.
1.
First, the NFS server must open an export directory and allow access to the IP address. Edit
the file “/etc/exports” on your Linux PC, and then run the NFS daemon. The following
example gives one possibility (refer to the NFS-HOWTO document at
/home/usr 192.168.3.1 (rw,no_root_squash,no_all_squash)
2.
The EM-1240-LX must run the “portmap” utility. This program is enabled by default in the
“/etc/rc” file. Use the following command to mount the remote NFS server:
/>mount –t nfs
Dynamic Driver Module Load/Unload
Besides supporting traditional static drivers, the EM-1240-LX also supports the dynamic driver
module load / unload mechanism. It allows user to load a special driver into the kernel to enable
hardware features for specific applications. To load / unload dynamic driver module, use the
following commands.
Load module:
/>insmod
For example, to load the UART driver, type the following command:
/>insmod /lib/modules/2.6.9-MoXaRt/kernel/drivers/char/mxser.ko
Show module list:
/>lsmod
Unload module:
/>rmmod
For example, to unload the UART driver, type the following command:
/>rmmod mxser
For the EM-1240-LX, the factory default is to load the UART driver “mxser.ko”. The additional
driver module to control SD/MMC memory card is loaded for the EM-1240-LX. Please see the
following information below to know the location and file name for these driver modules.
UART:
/lib/modules/2.6.9-MoXaRt/kernel/drivers/char/mxser.ko
SD/MMC:
/lib/modules/2.6.9-MoXaRt/kernel/drivers/mmc/mmc_core.ko
/lib/modules/2.6.9-MoXaRt/kernel/drivers/mmc/mmc_block.ko
/lib/modules/2.6.9-MoXaRt/kernel/drivers/mmc/moxasd.ko