Monessen Hearth C2802VF - Manual (Page 16)

16 45D0080 45D0080 17
Log #4
Log #2
Log
#1
Log
#3
Back
Pins
Front
Pins
LOG PLACEMENT
INSTALLING LOGS ON GRATE (See Figure 12)
1. Install back log (#1) on two pins located near the back of base. Check log
position and stability.
2. Install center log (#2) on two pins located near the front of the base.
3. Install front log (#3) in front of center log. Make sure bottom of log is
resting on the grate. Do not rest log on burner.
4. Place back end of top center log (#4) on recessed area of back log (#1) and
rest on pin on center log (#2).
Figure 12 - Installing Logs to
Grate
Before you begin — This unit is supplied with four ceramic fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with
soap and water to remove any traces of fibers.
The positioning of the logs are critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly positioned
in the appliance. Never add additional logs or embellishments such as pine cones,
vermiculite or rock wool to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts
specifically approved for this heater may result in property damage or personal
injury.
W
ARNING
DO NOT sprinkle volcanic rocks on the logs or
around the pilot. This may cause sooting.
During initial operation of the new heater, burning
logs will give off a paper burning smell and orange
flames will be present. Simply open the windows for
a few hours to vent the odor.
CAUTION