Philips CCB130CN - Manual (Page 40)

40 Real-Time Counter Memory
Follow the steps below to reset the real-time counter to zero at a
tape location you want to refer to later.
1
Play, fast forward, or rewind a tape to the location that
you would like to refer to later. Stop the tape.
2
Press the STATUS/EXIT button. The real-time counter will
appear on the screen.
3
While the counter remains on the screen, press the
CLEAR button to reset the real-time counter to zero.
4
While the counter remains on the screen, press the MEM-
ORY button so that M appears on the screen. To erase a
real-time counter memory, press the MEMORY button so that the
M disappears from the screen.
01:08 PM STOP
CH10
SLP 1 : 23 : 45
5
To go to a tape location where the real-time counter was
reset to zero, press the REW(ind)/s button or the
F.FWD/B button when playback is stopped. When the
tape reaches the point at which the counter was set to
zero, the tape will stop. Press the PLAY/o button to
watch the tape.
• The real-time counter memory will
not function during Repeat Play
mode. Details are on page 37.
• You may only set one real-time
counter memory at a time. If you
set the real-time counter to zero at
a second location, the previous real-
time counter to zero setting will be
lost.
Helpful Hints
0 : 00 : 00
M 0 : 00 : 00
1,5
2
4
3
VOL.
CH.
3 2 1
6 5 4
9 8 7
0
POWER
STATUS/EXIT
TRACKING REC/OTR
SPEED MEMORY
ALT. CH
PAUSE/STILL
MUTE
F.FWD REW
PLAY
STOP
SLEEP/WAKE UP
MENU CLEAR