Melissa 646-063 - Manual (Page 15)

PRIOR TO FIRST USE
Each individual appliance is checked at the
factory, but for safety’s sake, please check
carefully after unpacking for damage during
transport. Check for visible damage (e.g. cracks
or scratches). If the appliance appears to have
been damaged, contact the shop where you
bought it, and do not use it until it has been
checked by an authorised specialist.
Clean all parts that come in direct contact with
food before using the appliance for the first time.
Fitting the blender shaft
Fit the blender shaft to the motor unit by inserting
the spindle into the middle of the shaft, and into
the socket on the motor unit. Carefully turn the
shaft clockwise . To remove the shaft, turn it
carefully anti clockwise.
Blending in the jug
Attach the blender shaft to the motor unit as
described under Fitting the blender shaft. Place
the food items to be blended into the jug (5). Hold
the jug firmly with one hand. Place the blender
shaft into the jug until it touches the food items
and switch on by pressing one of the speed
selection switches (1) and holding it down. The
blender will run as long as you hold the button
down.
NB: We recommend the blender does not run
for more than 1 minute at a time when blending
or chopping. Allow the appliance to cool for a
little while before continuing.
Tips
•
Wash fruit and vegetables thoroughly before
blending them.
• Peel fruits such as oranges, lemons,
mandarins, mango, kiwi, melon and pineapple
before blending.
• Remove any pips, stones etc from fruit before
blending.
• Slice fruit and vegetables into small pieces
before putting them into the jug.
• Start at low speed (I) to avoid splashes in the
open jug. Switch to high speed (II) if and when
required.
CLEANING
• Remove the plug from the socket before
cleaning.
• Allow the blender to cool before dismantling
and/or cleaning.
• Do not use scouring powder, steel wool or
other aggressive cleaning materials, as they
can scratch the surface of the appliance.
• Use a damp cloth (warm water) and a little
detergent if necessary. Wipe off with a dry
cloth.
• Wash removable parts in warm water with a
little detergent added. Rinse all parts
thoroughly and dry before replacing them.
• Take great care when cleaning and handling
the blades as they are very sharp.
• Do not immerse the motor unit in water. Do
not allow water to seep into it.
INFORMATION ON DISPOSAL OF THIS
PRODUCT
Please note that this Adexi product is marked
with this symbol:
This means that this product must not be
disposed of together with ordinary household
waste, as electrical and electronic waste must be
disposed of separately.
In accordance with the WEEE directive, every
member state must ensure correct collection,
recovery, handling and recycling of electrical and
electronic waste. Private households in the EU
can take used equipment to special recycling
stations free of charge. In some member states
you can, in certain cases, return the used
equipment to the retailer from whom you
purchased it, if you are purchasing new
equipment. Contact your retailer, distributor or the
municipal authorities for further information on
what you should do with electrical and electronic
waste.
15
IM_646063 01/11/07 11:18 Side 15