Meyer Sound MPS-488HP - Manual (Page 16)

CHAPTER 3: CONNECTING LOUDSPEAKERS TO THE MPS-488HP
16
■ When connecting loudspeakers equipped with EN3 con-
nectors to the MPS-488HPe power supply, use EN3 5-
pin male to EN3 5-pin female cables.
■ To join two EN3 cables, one with an EN3 5-pin male
cable mount connector to one with an EN3 5-pin female
cable mount connector, use an EN3 5-pin female-to-
male cable coupler (PN 28.163.033.01).
5. Power on the MPS-488HP and monitor the LEDs on its
front panel to verify the connections (see “Voltage and
Load Current LEDs (1–8)” on page 9).
6. Check loudspeaker LEDs to verify whether the loud-
speakers are ready to reproduce audio.
7. Enable output from the audio sources (from the mixer or
processor) connected to the MPS-488HP.