beautypg.com

Warning, Electrical requirements, Settings – Maytag W10188231A User Manual

Page 3: Features

background image

3

Electrical Requirements

Observe all governing codes and ordinances.
Required:

A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.

Recommended:

A time-delay fuse or time-delay circuit breaker.

A separate circuit serving only this microwave oven.

Settings

Clock

The Clock is a 12- or 24-hour clock. Use Control Setup to change
mode, or to turn on or off Daylight Saving Time.
12 hour mode: Touch CLOCK, enter time, touch the Start control,
select A.M. or P.M., then touch Start control again.
24 hour mode: Touch CLOCK, enter time, then touch the Start
control.

Kitchen Timer

The kitchen timer can be used independently during any cooking
program. Touch the Timer control, enter time, then touch the Start
control.

Control Lock

Activate to avoid unintended start. Depending on your model, the
padlock graphic on the control panel is next to either the Start
control or Cancel control. Touch and hold the appropriate control
pad until the signal sounds and the lock indicator appears in the
display. Repeat to unlock control.

Vent Fan

High, low and off. Comes on automatically at the low setting when
it senses heat from the cooktop below. When this occurs, the vent
fan cannot be turned off. It may stay on for up to 1 hour to cool the
microwave oven.

Cooktop Light

High, low and off. Low setting may be used as night light.

Setup

Settings for the following may be changed: Weight (lbs or kg),
Sound (on or off), Clock display (12 or 24 hours), Display scroll
speed (slow, normal or fast), Remind end signal (on or off), Demo
Mode (on or off) and Daylight Saving Time (on or off).

Tones

Programming tones and signals which can be turned off or on
using the Control Setup.

Demo Mode

Activate to practice using the control without actually turning on
the magnetron. Use the Control Setup to activate or deactivate.

Features

Cooking Rack

Use only for 2-level cooking. To avoid damage to the microwave
oven, always remove rack after 2-level cooking. To avoid damage
to the microwave oven due to soil buildup, clean rack supports
often.

Turntable

Turntable may be turned off (on some models) for manual cooking
only. This is helpful when cooking with plates that are bigger than
the turntable, or when cooking with plates that are side by side.
Turntable cannot be turned off during preset or sensor (on some
models) functions.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

WARNING

GROUNDING INSTRUCTIONS

SAVE THESE INSTRUCTIONS

For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.

WARNING:

Improper use of the grounding plug can

result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.

Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.

This device complies with Part 18 of the FCC Rules.

This manual is related to the following products: