Minicom Advanced Systems Minicom Smart 216 - Manual (Page 46)

SMART 216 / 232 IP
45
Press F10. “Please wait” flashes a few times and disappears. The monitor’s DDC
information is sent to all ROCs.
29.7.1.1 Updating the DDC information
Update the DDC information in any of the following circumstances:
· When replacing the monitor connected to Smart 216 / 232 IP Switch
· When adding a new ROC to the system
· When reconnecting an existing ROC that was temporarily used in a
different system
To update the DDC information, repeat the steps as set out above.
29.8 Saving changes to the settings
To save changes to the settings and return to the Main window, press Esc.