Microsoft ICES-003 - Manual (Page 7)

en
gl
is
h
6
Black only
DISPOSALOFWASTEELECTRICAL
ANDELECTRONICEQUIPMENT
This symbol means that the disposal of
this product may be regulated. Disposal
with household waste may therefore be
restricted. It is your responsibility to comply
with applicable recycling law or regulations
pertaining to electrical and electronic
waste. Separate collection and recycling
will help to conserve natural resources and
prevent potential negative consequences for
human health and the environment, which
inappropriate disposal could cause due to the
possible presence of hazardous substances
in electrical and electronic equipment. For
more information about where to drop off
your electrical and electronic
waste, please contact your
local city/municipality office,
your household waste disposal
service, or the shop where you
purchased this product.
FORCUSTOMERSINTHE
UNITEDSTATES
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
This device may not cause harmful
interference, and
2 This device must accept any interference
received, including interference that may
cause undesired operation.
TradeName: Microsoft Corp.
ResponsibleParty: Microsoft Corporation
Address: One Microsoft Way
Redmond, WA 98052
U.S.A.
TelephoneNo.: (800) 4MY-XBOX
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Caution: Any changes or modifications made
on the system not expressly approved by the
manufacturer could void the user’s authority
to operate the equipment.
FORCUSTOMERSINCANADA
This Class B digital apparatus complies with
Canadian ICES-003.