Mercedes-Benz C-CLASS WAGON C 240 - Manual (Page 280)

278
Controls in detail
Useful features
Step 12:
̈ Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (2, 3
or 4).
Step 13:
̈ To program the remaining two buttons,
repeat the steps above starting with
step 3.
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
̈ Continue to press and hold the
integrated signal transmitter button
(2, 3 or 4) while you press and
re-press (“cycle”) your hand-held
remote control transmitter 6 every
two seconds until the frequency signal
has been learned. Upon successful
training, the indicator lamp 1 will
flash slowly and then rapidly after
several seconds.
̈ Proceed with programming step 5 and
step 6 to complete.
୴୴