Milan Technology MIL-S16000T - Manual (Page 9)

3.
Hardware Installation
Desktop Installation
Set the switch on a sufficiently large flat space with a power outlet nearby. The
surface where you put your switch should be clean, smooth, level, and sturdy.
Provide enough clearance around the switch to allow attachment of cables, power
cord and air circulation.
Attaching Rubber Feet
A. Make sure the mounting surface on the bottom of the Switch is grease and
dust free.
B. Remove adhesive backing from the rubber feet.
C. Apply the rubber feet to each corner on the bottom of the switch.
These footpads can prevent the Switch from shock/vibration.
Figure 3-1. Attaching Rubber Feet to each corner on the bottom of the Switch
6