Moffat Blue Seal E20AC - Manual (Page 2)

4517 BS ACSeries specs V3 24/6/05 10:52 AM Page 10
Australia
Moffat Pty Limited
Victoria/Tasmania
740 Springvale Road
Mulgrave, Victoria 3170
Telephone 03-9518 3888
Facsimile 03-9518 3833
[email protected]
New South Wales
Telephone 02-8833 4111
[email protected]
South Australia
Telephone 03-9518 3888
[email protected]
Queensland
Telephone 07-3630 8600
[email protected]
Western Australia
Telephone 08-9562 0263
[email protected]
New Zealand
Moffat Limited
Christchurch
Telephone 03-389 1007
[email protected]
Auckland
Telephone 09-574 3150
[email protected]
Australia
www.moffat.com.au
New Zealand
www.moffat.co.nz
Printed in China
© Copyright Moffat Ltd
Moffat/4517-E20/BH/3.5M/6.05
Dimensions
Width 1170mm
Depth 895mm
Height 1090mm
Weight 230kg
Packed Dimensions
Width 1320mm
Depth 1040mm
Height 1220mm
Weight 255kg
Shelves
1/1 GN 20
2/1 GN 10
Shelf Spacings 70mm
Installation requirements
(for precise installation
instructions, please refer to the
unit’s installation manual).
Power connection requirements
Multi pole circuit breaker and all
pole disconnection isolator switch
installed near the appliance.
Supply line voltage;
400-415V ~ 50Hz, 3P+N+E
Special voltage options available
on request.
Power Connection
Total (kW) 31
Convection power (kW) 30
Rated Current (A) (400V) 45
IPX5 spray-proof and hose proof.
Installation clearances
- rear 25mm
- right 500mm*
- left 50mm
*Clearance required on fixed
installations for service
accessibility.
If heat sources are located near
the RH side of the AC combi,
ensure that a minimum distance
of 400mm is maintained.
Install in accordance with local
body regulations only on horizontal
surfaces and not against
combustible walls.
Water connection requirements
- Cold water
- Flow pressure (2 to 6 bar)
- soft water connection*
- shut-off valve with return flow
inhibitor and dirt filter
- water supply R3/4
- R50 waste water connection
(*Water softener may be required.
Please refer to installation manual
for water treatment values.)
In line with policy to continually develop
and improve its products, Moffat Limited
reserves the right to change
specifications and design without notice.
T E C H N I C A L S P E C I F I C A T I O N S H E E T F O R
BLUE SEAL ELECTRIC COMBI STEAMER
AC SERIES E20AC DD 20 x 1/1GN or 10 x 2/1
A = WATER CONNECTION R 3 / 4
(SOFTENED WATER) refer to installation
manual for water treatment values.
B = WATER CONNECTION R 3 / 4
C = DRAIN CONNECTION Ø60
D = ELECTRICAL CONNECTION ENTRY
E = HIGH/LOW PRESSURE RELIEF VENT
F = OVEN VENT Ø80
Optional Extras
SC Core temperature probe
SPT20 Stainless steel stand with 12 x 1/1 or 6 x 2/1 GN shelves to suit
20AC DD
SST20 Removable rack complete with fitting frame alternative to side
runners to suit 20AC DD
TLT20 Removable frame for oven and plate racks to suit 20AC DD
SGT20 Removable oven rack to suit 20AC DD
PRT20 Plate banquet rack to suit 20AC DD / 60 plates
CRT20 Trolley for removable oven rack with drip tray to suit 20AC DD
CPT20 Thermal cover for plate banqueting system to suit 20AC DD
KP004 Set of four legs for bench mounting