Mr. Coffee TM10 - Manual (Page 6)

C/eaning Your Iced Tea Pot Before First Use
1.
2.
3.
4.
5.
6.
Please clean your unit prior to first use (or when unit has not been used for
some time).
First unplug unit from electrical outlet. Wash the pitcher and lid with warm
water and mild detergent. Rinse thoroughly. Wipe exterior and brewer with
a soft, damp cloth, then dry with a soft towel. DO NOT use abrasive
ers or metal scouring pads. Do NOT IMMERSE OR RINSE UNDERSIDE
OF BREWER IN WATER. NO PARTS ARE DISHWASHER SAFE.
Fill pitcher with water to the water level line marked on the pitcher and
pour into the brewer - approximately 32 ounces. The water will not leak
from the brewer.
Place the brewer, with lid, onto the pitcher. Make sure the brewer and
pitcher fit together snugly.
CAUTION: Do not operate the machine unless the pitcher and brewer
with Iid fit snugly together; otherwise, hot water-and steam could
escape. DO NOT OPERATE WlTHOUT LID TO AVOID RISK OF
SCALDING AND BURNS FROM HOT WATER AND STEAM.
Plug the cord into an electrical outlet and push the ON button to turn the
machine on. The indicator light will illuminate to tell you that the machine
is on. PLEASE NOTE: The first time the machine is used, it may not be
necessary to depress the ON button to turn fhe machine on; simply plug-
ging the machine into an outlet may start the brew cycle. Also, If the
ON button is depressed before the machine is plugged into an outlet,
plugging the machine into an outlet will start the brewing process.
Note: if you wish to turn the machine OFF during the brew cycle, grasp
the molded plug and unplug the power cord
When the water has cycled through, the machine will shut off automati-
cally. The indicator light will turn off to let you know the cycle is over.
Grasp the molded plug and unplug the power cord. CAUTION: Some
residual steam may escape from the brewer when the cycle is
over.
CAUTION: The liquid in this brewer Is very hot and can cause burns.
Handle with caution.
CAUTION: Use care when Iifting the brewer from the pitcher.
A seal may have formed during the brewing process. Lift and
remove the brewer from the pitcher using the brewer handle, and
discard the water in the pitcher. (as referred to on page 9