Muratec F-150 - Manual (Page 80)

Beyond the basics
5 To change the setting, press or / PROGRAM repeatedly until your desired
setting appears. In this example, we’ve chosen “Mode1.”
6 Press ENTER .
Autodialing while using the PIN mask
Note: The following instructions presume you are familiar with how to set and use
your machine’s autodialer. If you need to review, see pages 2.8–2.16.
Note: If the PIN mask feature is off, you use the autodialer normally.
If you’ve specified “Mode 1” — the PIN goes in
In this mode, before autodialing the desired number the first time, you must add
the
PIN to its stored one-touch key or speed-dial number. Here’s how:
1 Make a normal autodialer entry through the entry of the call group(s).
The
LCD will show:
2 Use the numeric keypad to enter the four-digit passcode. Here, we’ll use our
sample passcode again.
3 Press ENTER . In our example, we’re setting speed-dial number 001:
4 Use the numeric keypad (including either * or #, if necessary) to enter the
desired
PIN , up to eight characters in length.
5 Press ENTER to save the PIN .
Note: If you press ENTER without entering the PIN , the fax machine beeps,
indicates “Invalid Number” on the LCD and then returns you to step 3.
Now you may autodial the number as usual.
Important: While in PIN Mode 1, any autodialer numbers you use must include
the PIN . Thus, this applies also to autodialer numbers used with batch
transmission (see pages 2.24–2.27) or programmable one-touch keys
(see pages 2.36–2.43).
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission
(see pages 2.24–2.27), you must store the PIN access code for the remote unit
within the appropriate batch box.
If you’ve specified “Mode 2” — as you autodial, load the code
In this mode, you don’t have to add the PIN to the autodialer setting itself. Instead,
you enter the PIN manually each time you autodial:
1 Perform the usual autodialing procedure for the number itself. Here, we’ve
pushed one-touch key
A :
2 Press START . The machine now asks for the PIN :
3 Use the numeric keypad to enter the PIN .
4 Press START . Your machine will dial the number.
Note: If you select either Mode 1 or Mode 2 and will be using batch transmission
(see pages 2.24–2.27), you must store the PIN access code for the remote unit
within the appropriate batch box.
Enter PIN Number
1057_
Enter PIN Number
_
Press Start
A_
001:PIN Number
1057_
001:PIN Number
_
Set PIN Number
Set PIN Number
PIN Mode:
Mode1
2.51