Philips Magnavox MPF68A - Manual (Page 10)

10
MENU 1 -
A. Press [MENU 1] key continuously, menu screen will
appear as follows:
B. Press [P+] [P-] key, cursor up or down.
Press [V+] [V-] key, change value for selection .
Note: Tint only for NTSC system.
Auto Search Function
Automatic Search and Memory (ASM) for program
installation from Antenna input. The TV will search through
the whole channel coverage and store all programs being
transmitted, in sequential order.
A. Press [MENU 1] key repeatedly to select “PRESET”
B. Press [P+] or [P-] key, to select “ASM”
C. Press [V+] or [V-] key, to start ASM.and memorize into
program list (0-255).
D. Wait until the process is completed.
On remote control, press [MENU] key on front panel and
hold for three seconds, TV set will enter “ASM” mode.
Search Function
Manual Search for Antenna input.
A. Press [MENU 1] key repeatedly to select “PRESET”
B. Using [P+] or [P-] key, select “PROGRAM”.
Using [V+] or [V-] keys to change Program Number.
C. Press [P+] or [P-] key to select “BAND”. Press [V+] or
[V-] key to change BAND.
D. Press [P+] or [P-] key to select “SEARCH”.
Press [V+] or [V-] key to enter SEARCH screen.
Press [V+] or [V-] key to start SEARCH.
E. The SEARCH function will locate channels in
sequential order and will halt when a channel is found.
Should this not be the channel you are seeking, press
the [V+] button again to recommence search.
Band: You can select V-L, V-H or UHF.
Channel 2 = V-L, Channels 7,9 & 10 = V-H,
Channel SBS = UHF.
F. Wait until the process is completed.
Tuning Procedure