Monster Power HTPS7000 User Manual

Page 31

TROUBLESHOOTING (CONTINUED)

Possible Cause #3:
The PowerSource's power cord is plugged into an outlet on the back of one of your components and the component
is not turned on.

Possible Solution:
• Turn the component on.

NOTE: For the best possible performance, plug the PowerSource into a wall outlet, not an outlet on another

component.
Possible Cause #4
The PowerSource is defective.

Possible Solution:
• Please see page 31 for warranty information.

PROBLEM – PowerSource is not providing power to the components.

Possible Cause #1:
The component is plugged into an outlet programmed as “switched on” or “switched on after delay” and the
PowerSource has not been turned on.

Possible Solutions:
• Press the ON/OFF button on the PowerSource. The components plugged into the PowerSource's outlets

programmed as "switched on” should be turn on immediately.
• Press the ON/OFF button on the PowerSource and wait for a few seconds for the components plugged into

the PowerSource's outlets programmed as “switched on after delay” to be turn on.

OR, plug the component into an outlet programmed as "unswitched".