Multi-Tech Systems Hub User Manual
Page 15
CommPlete 4000 Communications Server User Guide
15
Chapter 3 - Getting Started with RASExpress
iii. Select ISI Setup.
iv. Delete all ISI cards before saving and rebooting the server.
These steps correct the initial subnet error the next time the server loads.
If you set the
Remote Client IP Address
to any of these values (
Use DHCP, or Use
Address Pool, Use Radius
), go to step A15. If you selected
Use Address Pool
, you
must configure the address pool. See the RAS
Express User Guide.
A15. When the above steps are complete, press
Esc
and save the changes to disk. You will be
asked to re-boot the server.
A16. Type Y and press
Enter
. The connection closes while the RAS
Express server re-boots. A
new menu appears after the CommPlete 4000 has re-booted.
A17. To complete the configuration of the RASExpress server, select
Configuration of server
from the main menu. For detailed information about the menu options, see Chapter 3 of the
RAS
Express manual.