Not dolby digital 5.1), Satellite speaker wiring options, Figure 4 - satellite speaker wiring (optional) – MK Sound K-9 User Manual
Page 8: Page 8 powered subwoofers, Amplifier or receiver, Satellite speakers
page 8
powered subwoofers
If your receiver or amp has two sets of speaker outputs, you may connect the
Satellite speakers to one set of outputs and the Subwoofer to the other set.
FIGURE 3 - TO AN AMP OR RECEIVER USING SPEAKER WIRES
IMPORTANT NOTE FOR DOLBY PRO LOGIC SURROUND SYSTEMS:
(NOT DOLBY DIGITAL 5.1)
When the Subwoofer is connected to the Left and Right amplifier outputs, the Center channel WIDE/
NORMAL switch MUST be set to the NORMAL mode. If the switch is set to the WIDE mode, the bass content
of the Center channel will not be fed to the Subwoofer, and a significant amount of bass in the program material
will not be reproduced.
SATELLITE SPEAKER WIRING OPTIONS
If you use speaker wires to connect the subwoofer, you have two options for the Satellite speakers.
1.
Connect both the Satellite speakers and the subwoofer direct to your amp or receiver, with one
set of wires running to the Satellites and another set to the Subwoofer. See Figure 4, below.
100
PHASE
10391 Jefferson Blvd, Culver City, CA 90232 310/204-2854 www.mksound.com
MILLER & KREISEL SOUND CORPORATION
RIGHT
INPUT
LOW PASS FILTER
(Hz)
FR
OM AMPLIFIER
50
75
60
125
T
2 AMP
120 VAC 50/60 Hz
RIGHT
LEFT
LEFT/MONO
SLOW-BLOW
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE DE MEME TYPE.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY
WITH SAME TYPE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
+
-
BASS LEVEL
+3 dB
+6 dB
- 3 dB
- 6 dB
REFERENCE
+9 dB
BYPASS
VARIABLE
!
+
+
+
+
AMPLIFIER OR RECEIVER
100
PHASE
10391 Jefferson Blvd, Culver City, CA 90232 310/204-2854 www.mksound.com
MILLER & KREISEL SOUND CORPORATION
RIGHT
INPUT
LOW PASS FILTER
(Hz)
FR
OM AMPLIFIER
50
75
60
125
T
2 AMP
120 VAC 50/60 Hz
RIGHT
LEFT
LEFT/MONO
SLOW-BLOW
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE DE MEME TYPE.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY
WITH SAME TYPE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
+
-
BASS LEVEL
+3 dB
+6 dB
- 3 dB
- 6 dB
REFERENCE
+9 dB
BYPASS
VARIABLE
!
+
+
+
+
AMPLIFIER OR RECEIVER
+
+
RIGHT
LEFT
SATELLITE SPEAKERS
FIGURE 4 - SATELLITE SPEAKER WIRING (OPTIONAL)
NOTE: See Fig. 4 for additional options