Miele H 387-1 B KAT - Manual (Page 65)

Installation, maintenance and
repairs to the electrical components
of this appliance should only be
carried out by a suitably qualified
and competent person in accor-
dance with national and local safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held responsible for
unauthorised work.
Some minor problems however can be
dealt with as follows:
What to do if . . .
. . . the oven does not heat up.
Check whether,
^ the selector switch is set to the func-
tion required, and the temperature
control is set at the correct tempera-
ture.
^ the operating lock is activated.
^ the mains fuse has blown. Contact a
qualified electrician or the Miele Ser-
vice Department.
. . . the heating works, but not the
oven lighting.
Make sure the halogen lamp is con-
nected properly in its socket.
If after checking it, it still does not work
you will need to change it:
^ Disconnect the appliance from the
electricity supply. Switch off at the
isolator or the mains fuse box.
^ Take out the runners.
^ Use the slide opener to lift the lamp
cover from its retainers.
^ Change the halogen lamp:
12 V, 20 W, heat resistant to 300°C,
Osram, Type w969.
Exercise caution when changing a
lamp. Halogen lamps get very hot dur-
ing use and will remain hot for some
time after being switched off.
Do not touch the surface directly when
changing the lamp as grease particles
from your fingers will adhere to the sur-
face and damage it. Please follow the
manufacturer's instructions.
Reassemble in the reverse order, care-
fully ensuring all parts are correctly in
place.
Correcting minor faults
65