Memorex MMP3682 - Manual (Page 7)

24 23
21 22
MMP3682
MP3/WMA
●
Technical Specifications
Category Item
Audio
Frequency Range
Headphone Output
S/N Ratio
20Hz - 20KHz
20mW, 16ohm (Max.Vol)
85dB (MP3)
File Support
File Type
Bit Rate
Tag Info
MPEG 1/2/2.5 Layer 3, WMA, WAV (ADPCM), (WMA with DRM)
8Kbps - 320 Kbps
ID3 Tag
Specification
Dimension
Battery
1 AA size Alkaline Battery
LCD Full Graphics
Language English
USB USB2.0
External Memory SD or MMC
Built-in Memory 128MB
Max. Playtime Approx. 18 hours (128Kbps, MP3)
Supported OS Win ME, Win 2000, Win XP
Firmware Upgradeable Yes (except Win 98)
Operating Temperature -5 o C to 40 o C
O 63mmX62mmX20mm
MMP3682
MP3/WMA
MMP3642
MP3/WMA
●
Firmware Upgrade Procedure
For WinME, Win2000 or WinXP only
Your new player shipped with the most current version of the firmware available.
No update is required at this time.
1. Install the "Memorex Solid State Digital Audio Player" program in your computer
1.1 Insert the Installation CD
1.2 An InstallShield Wizard will pop up automatically
1.3 Click on Next to proceed the installation
1.4 Once the installation is done, click on Finish
2. Firmware Download
2.1 Download the latest firmware from our website www.memorexeletronics.com.
Unzip the firmware file into the directory C:\Program Files\Memorex\Digital
Audio Player
2.2 Click on Start and select Program. From program, select the Memorex Solid
State Digital Audio Player, then click on Update.
2.3 An Update dialogue box will pop up. Click on Start and the application
program will begin to download the firmware.
Remarks: Some memory space in Flash Memory is reserved for Firmware Upgrade
Features. Therefore, usable memory space will be less than 128MB.
MMP3682
MP3/WMA
WARNING!
Do not format this player unless it stops working and you are instructed to do
so by technical support personnel.
●
Formatting the Player
1. Click on Start and select Program. From program, select the Memorex Solid
State Digital Audio Player, then click on Format.
2. A Format dialogue box will pop up, click on Start and the application program
will format the Player.
Do not update the firmware unless you are experiencing problems with your
digital audio device. Incorrect or faulty firmware installation will cause the
player to stop functioning.
Symptom Possible Reason
 Not supported file type.
Actions
 Make sure the files are MP3 or WMA.
 Poor connection to PC.  Check both connections- you may
need to conect the player to a
USB port on the back of your PC.
 Perform the Firmware update
procedure- see page 23.
 Corrupted files or firmware
No fies are
showing on the
player after
transfer
Player doesn’t
display “Mass
Storage
Device”
No power after
loading files
When I turn my
player on,
“Hold” and
appears.
 Hold switch is on.  See page 5 for location of
hold switch.
MMP3682
MP3/WMA
“ ”