Magnadyne Silencer Security Systems ALA200FKE - Manual (Page 4)

4
2. Press the LOCK button on your Silencer transmitter. Your Silencer security system will respond in the
following manner:
A. The vehicle horn will beep one time.
B. The parking lights may flash one time. (Parking light flash option required)
C. The LED indicator for the security system will start to flash.
The system is now armed.
3. Press the UNLOCK button on your Silencer remote transmitter. Your Silencer security system will
respond in the following manner:
A. The vehicle horn will beep twice.
B. The parking lights may flash two times. (Parking light flash option required)
C. The LED indicator for the security system will start flashing fast indicating that the system will
rearm in 60 seconds. (Opening the drivers door or turning on the ignition key will momentarily stop
the auto arming feature.)
The system is now disarmed.
Automatic Arming with Manual Disarming
Note: When you take delivery of your new vehicle with a Silencer ALA200FKE security system, the
automatic arming feature is active to protect your vehicle even if you forget to arm your security system.
If the feature becomes undesirable, it can be programmed off leaving manual arming your only method
to secure your vehicle. Contact your dealer for further information.
1. Exit the vehicle and close all protected entrances. Once the last protected entrance is closed, your
Silencer security system will respond in the following manner:
A. The vehicle horn will beep one time.
B. The LED indicator will begin to flash fast to indicate that the 30 second auto arm timer is counting down.
2. After 30 seconds has passed**, your Silencer security system will respond as follows:
A. The vehicle horn will beep once again indicating that the security system is fully armed.
B. The parking lights may flash one time. (Parking light flash option required)
C. The LED indicator will resume a normal flash speed indicating an armed condition.
D. The doors will become locked. (*See Note 2.)
Note 1: Once the ignition key switch is turned off, the automatic arming timer will start counting
after the last protected entrance is closed. Opening any protected entrance within the 30 second
time will stop the counter and reset it. Closing the entrance will start the counter once again but you
will not get a beep when closing the door for the second time.
Note 2: Auto arm door lock control is an optional feature described in the back of this manual.
** The dome lights in some vehicles have a delay before they turn completely off. If your vehicle has
this type of delay, the 30 second auto arm timer will start when the dome light is completely off.
Depending on the length of time it takes the dome light to turn off, auto arming may take 45 to 60
seconds or more.
What to do if the Alarm is Sounding
Press the UNLOCK button on your Silencer transmitter.
1. The vehicle horn will stop beeping.
2.
If the parking lights are flashing they will stop flashing. (Parking light flash option required)
3. The LED indicator will begin a special tamper mode flash sequence to let you know that your alarm had been
triggered.
Notations on Basic Operating Procedures:
1. When you disarm the system while it is sounding, there are no disarm chirps.
2. After the security system has been triggered, the LED remains flashing even thought the security system has
been disarmed. This is a tamper indicator. Turning on the ignition key will reset this indicator.
System Control by the Silencer Remote Transmitter (Basic Operation) (continued)