Makita Random Orbit Sander BO5040 - Manual (Page 6)

6
pad. Be careful to align the holes in the abrasive disc with
those in the pad.
CAUTION:
•
If you peel off the abrasive disc from the pad, its
adhesion will become poor. Never attempt to stick it
onto the pad for further use.
Installing dust bag
1
010746
Install the dust bag on the tool so that the Makita logo on
the dust bag will be upright (not upside down).
Emptying dust bag
1
003323
When the dust bag is about half full, switch off and unplug
the tool. Remove the dust bag from the tool. Then remove
the dust nozzle from the dust bag after unlocking the dust
nozzle by turning it slightly counterclockwise. Empty the
dust bag by tapping it lightly.
1
003326
After emptying the dust bag, install the dust nozzle on the
dust bag. Turn the dust nozzle slightly clockwise to lock it
in place. Then install the dust bag on the tool as
described in "Installing dust bag".
Installing paper dust bag
1
2
3
003742
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing cardboard
of the paper dust bag into the groove of the paper dust
bag holder.
1
2
003743
Then press the upper part of the front fixing cardboard in
arrow direction to hook it onto the claws.
1
2
003744
003745
Insert the notch of the paper dust bag into the guide of
the paper dust bag holder. Then install the paper dust
bag holder set on the tool.
1. Notch
2. Guide
1. Claws
2. Upper part
1. Groove
2. Front fixing
cardboard
3. Front side of
paper dust bag
1. Dust nozzle
1. Dust nozzle
1. Dust bag