Monte Carlo Fan Company 5KBR54 - Manual (Page 3)

install cotter pin into cross pin.
Install downrod into yoke.
Install 4 x 40 watt candelabra base bulbs
included.
Raise fan with downrod assembled to the ceil-
ing bracket and hang fan assembly. Be sure to
rotate the downrod ball so that the notch in the
bracket engages the slot in the ball.
9
14
17
12
For Canadian installation in both flush and
downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws provided. Make sure that
when the safety cable is fully extended the
leadwires are longer than the cable and no
stress is placed on the leadwires.
18 Canadian mounting only
Safety Cable
Lag Screw
Loosen 2 screws and remove pin with keeper
for downrod, yoke cover and canopy to fit in
yoke of fan.
11
Install canopy and yoke cover onto downrod as
shown. Thread wires and safety cable through
downrod.
10
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
16
Lift mounting neck to mounting Plate and align
screws.
7
Secure mounting neck to the mounting plate
with four screws to become a complete mount-
ing bracket.
8
Tighten 2 downrod set screws and lock nuts.
15
Align hole in downrod with hole in yoke and
install cross pin.
13