Philips AZ 1045 - Manual (Page 10)

English
BASIC FUNCTIONS GENERAL INFORMATION
10
Switching on and off
• Adjust the POWER slider to the desired sound source:
CD, TUNER or TAPE.
• The set is switched off when the POWER slider is in the
TAPE/OFF position and the keys on the tape deck are
released.
™ The volume and tuner presets will be retained in the set's
memory.
Adjusting volume and sound
1. On the set press the VOLUME control to increase or decrease
volume (or press
3 or 4 on the remote control).
™ Display shows the volume level VOL and a number from 0-32.
2. Adjust the DBB control to select dynamic bass boost on or off.
PHILIPS demo mode
1. On the set or remote control, press the CD STOP
9 button for
5 seconds.
™ After about 30 seconds, PH..IL ..IPS scrolls across the display.
2. To return to the current display you can either:
• press any function button on the front panel. This interrupts
the demo mode for 30 seconds;
• press the CD STOP
9 button for 5 seconds. PH..IL ..IPS
scrolls once before the demo mode is cancelled.
GENERAL INFORMATION
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.
Safety information
• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
AZ 1045 /17
page
10
CD R
P
SEARCH
STOP-OP EN
PAUSE
DBB
POWER
TUNER
DYNAM IC BASS BOOST
CD TAPE OFF
VOLUME
REMOTE
SENSOR
STOP-OP EN
PAUSE
SHUFFLE
DBB
POWER
TUNER
DYNAM IC BASS BOOST
CD TAPE OFF
CD
PROG
BATT
LOW
MODE
ME
STOP
PLAY•PA
USE
SEARCH
REMOTE SENSOR
SHUFFLE ALL
PRESET
CD
DIGITAL
TUNER