Miele TOUCHTRONIC G 694 SC - Manual (Page 15)

Programming the water softener
Your water hardness level must be pro-
grammed into the dishwasher using the
buttons on the control panel.
The programming can be cancelled
and restarted at any time by turning
the dishwasher off with the "On/Off"
button (13).
^ Make sure the dishwasher is turned
off.
^ Press and hold the "Top Solo" (20)
and "Start/Stop" (18) buttons and at
the same time turn on the dishwasher
with the "On/Off" (13) button. Release
all buttons.
The "Rinse" (16) indicator will light and
the "Salt" (15) indicator will flash.
If this is not the case, the above steps
must be repeated.
a 4 will flash in the delay start display.
^ Use the program selection buttons
(21) to select the value which corre-
sponds to the water hardness in your
area (see Table 1).
The selected value will appear in the
time display.
To store the programmed water hard-
ness:
^ Press the "Start/Stop" (18) button
twice.
The "Start/Stop" (18) indicator will flash.
^ Turn off the dishwasher.
Before using for the first time
15