Philips Magnavox 13MT1432/17 - Manual (Page 5)

I f Cable TV signal into your home is a
single cable (75 ohm) the connection
to the TV is easy.
1 Connect the Cable TV cable
directly to the 75
Ω jack on the
TV.
Basic Cable TV Connection
Basic Antenna Connection
75 Ω
75 Ω
Cable TV Signal
RF Coaxial
Cable 75
Ω
Rear of TV
A combination antenna receives normal
broadcast channels (VHF 2-13 and
UHF 14-69). Your connection is easy
since there is only one 75
Ω (ohm)
antenna plug on the back of your TV -
and that’s where the antenna goes.
1 If your antenna has a round
cable (75 ohm) on the end, then
you're ready to connect it to the
TV. Go to step 2.
If your antenna has flat twin-
lead wire (300 ohm), you first
need to attach the antenna wires
to the screws on a 300 to 75
ohm adapter (not supplied with
TV).
2 Push the round end of the
adapter or antenna cable onto
the 75
Ω jack on the rear of the
TV. If the round end of the
antenna cable is threaded, screw
it down tight.
1
75 Ω
75 Ω
Combination
VHF/UHF Antenna
(Outdoor or Indoor)
Twin Lead
Wire
Round Cable 75 Ω
Rear of TV
If no Video Signal is present, the TV
will display a “BLUE” screen and shut
itself off in about 5 minutes. If the TV
is tuned to the AV channel and there
is no Video Signal present, the screen
will remain black and the TV will shut
itself off in about 5 minutes.
Use Auto Program as described on
panel 9 to set up channels that are
available in your area. Use the CH +/–
buttons to scan available channels.
Helpful Hints