Marantz VP-12S2 - Manual (Page 6)

ENGLISH
2
FEATURES
❖
Optics
• Texas Instruments DLP TM (Digital Light Processing)
Technology
• 1280 x 720 DMD TM Panel
• 16 : 9 Aspect Ratio
• Custom Optics Developed by Minolta
• 2600 : 1 Contrast Ratio
• 700 ANSI Lumens Brightness
• Brightness Uniformity : 90 %
• No Halo Effect
• Lens Up/Down Shift Construction
• Dust Free Optics Sealing
• No Light Leakage (Double Seals Cabinet Structure)
• Extremely Quite (Noise Cancel Duct Construction,
Ceiling Color Wheel Motor)
• Long Life Lamp (Average 2000 Hours)
• Double Shrink Seal Lamp Structure Minimizes
Burst Ratio
❖
Electronics & Software
• Full Digital Device
• 3 Faroudja Chips Inside (Decoder, Doubler, and
Enhancer)
• 3-2 Pull Down
• 10-Bit Digital Gamma Processing
• Horizontal/Vertical Keystone Correction
• 480p, 720p,1080i adapted
• Four Picture Modes: Theater, Standard, Dynamic,
User
• Twelve Picture Memories
• 4 Aspect Modes
• Fine Menu
• Three Color Temperatures (5250K/6500K/9000K)
• Black Level Selection (0IRE/7.5IRE)
• Control through RS-232C
• Two trigger for powered Screen Control
• Ecology Lamp Mode
• Component Video Input
– DLP, Digital Micromirror Device and DMD are trademarks
of Texas Instruments.
– “DCDi” is a trademark of Faroudja, a division of Sage Inc.
– All trademarked product names mentioned in this manual
are the property of their respective companies.
Note: Pixel defects
DMD TM (Digital Micromirror Device TM ) is one of the most
advanced technologies for consumer products. The DMD TM
made by high precision technology, however some pixel
defects may be found on the projected image. We are
trying our best to control the quality in order to reduce the
number of defective pixels. It is almost impossible to have
zero pixel defects, even using the most advanced
technology. This is not a problem only for Marantz, but all
DLP
TM projector manufactures. Therefore we have to note
that the warranty does not cover the DMD TM for pixel
defects. We appreciate your understandings.
Note: Lamp
SHP lamp is one of the most advanced technologies for
consumer products. The lamp made by high precision
technology, however some lamps might be failing before it
reaches its life. And projector’s brightness is getting darker
along with accumulated lamp usage hours. We are trying
our best to control the quality in order to reduce lamp
failures. It is almost impossible to have zero failure, even
using the most advanced technology. This is not a problem
only for Marantz, but all projector manufactures. Therefore
we have to note that the warranty does not cover the SHP
lamp for lamp failures: explosion, and non-lighting except
initial use. And also we have to note that the warranty does
not cover the SHP lamp for lamp failures: flickering, and
getting darker along with accumulated lamp usage hours.
We appreciate your understandings.