Mitel SME Server V5 with ServiceLink - Manual (Page 26)

Chapter 5. Hardware Requirements of the SME Server V5 with ServiceLink Host Computer
5.4. Hardware Requirements for a Category 4 Server
Table 5-7. Definition of a Category 4 Server
# of Users Up to 500
Usage Heavy
Table 5-8. Hardware Requirements of a Category 4 Server
Architecture PCI-based Pentium-class processor
Processor speed 700 MHz (or better)
Minimum RAM 256 MB
Hard drive SCSI - at least 20 GB (2 large SCSI drives using RAID1 strongly recommended)
SCSI adapter SCSI adapter must appear on the supported list
Ethernet adapters The ethernet adapters installed on your server must appear on the supported list.
Modem (for dialup only) Only modems that are Linux-compatible may be used. WinModems are not supported.
CD-ROM drive ATAPI or SCSI
Floppy drive any
Monitor any
Graphics card any
Mouse none required
Sound card none required
5.5. Supported Ethernet Adapters
Either one ethernet adapter (in the case of dialup connectivity or server-only mode) or two ethernet adapters (for dedicated
connections in server and gateway mode) must be installed on your SME Server V5 with ServiceLink. This section describes which
types of ethernet adapter can be used in the computer that will become your server. (There are no restrictions on the ethernet adapters
in your other computers.)
Any adapters installed on the server must appear on the following supported list. Note that only PCI adapters are supported. The
PCMCIA adapters used in many laptops and the older ISA adapters are not supported.
Note: Because SME Server V5 with ServiceLink is based on Red Hat Linux version 7.1, PCI ethernet adapters that can work with
Red Hat 7.1 should also work with SME Server V5 with ServiceLink. You can find an up-to-date searchable database at Red Hat’s
web site at: http://hardware.redhat.com/redhatready/cgi-bin/us/db-hcl.cgi (Choose
Network Device/Controller from the
"Hardware Category" menu.)
26