Memorex MVT2137 - Manual (Page 24)

24
If you connect the TV/VCR to another VCR or
Camcorder, you can duplicate a previously recorded
tape. Make all connections before turning on the power.
1 Insert a blank cassette with the erase prevention tab
intact into the TV/VCR.
Insert a previously recorded cassette into the play-
back VCR or Camcorder.
2 Press the INPUT SELECT button
twice to select AUDIO/VIDEO
input position. The "LINE 2" will
appear on the screen.
NOTE: You can also use the rear AUDIO/VIDEO
LINE1 Jacks. Select "LINE 1" by pressing the
INPUT SELECT button.
3 Press the REC/OTR button on the remote control of
the TV/VCR, then press the PAUSE/STILL button.
4 Press the PLAY Button on the playback VCR, then
press the PAUSE/STILL button.
5 Press the PAUSE/STILL buttons on both units
simultaneously to begin the duplicating process.
NOTES: • It is recommended that the tape speed be set
to the SP mode on the TV/VCR for best result.
• Unauthorized recording of copyrighted
television programs, films, video cassettes
and other materials may infringe the rights of
copyright owners and be contrary to copyright
laws.
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer’s instruc-
tions. A typical camcorder dubbing hookup is shown
below.
DUPLICATING A VIDEO TAPE
CONNECTION TO ANOTHER VCR
To AUDIO
OUT To VIDEO
OUT
Playback VCR
Audio/Video Cord (not supplied)
Recording TV/VCR
To
Audio In To Video In
CONNECTION TO CAMCORDER
Playback
Camcorder
To Video/Audio In
Audio/Video Cord (not supplied)
To AV Jack
Recording TV/VCR
LINE 2
5A3A901A E P20-Back 3/18/02, 10:08 PM 24