Miele DA 3180 EN - Manual (Page 32)

6. Install the grease filter
^ Remove the protective film from the
grease filter frame.
^ To reinsert the grease filter, pull the
deflector out.
^ Make sure that the red plastic
guides are at the front and facing up.
^ Insert the grease filter into the
deflector, and push upwards. It
should glide onto the fixing pins.
7. Venting
Air extraction mode
^ Complete the venting installation, see
"Air extraction".
Recirculation mode
If the hood cannot be installed for air
extraction the appliance must be
connected for recirculation mode.
For recirculation mode a respective
installation kit is recommended which
can be obtained from Miele.
In addition an active charcoal filter is
needed.
^ The non-return flap is not needed for
the recirculation mode. Pull the
non-return flap off the bracket from
the vent connection.
Installation
32