Moxa Technologies UPORT 1130 - Manual (Page 10)

2 2
Chapter 2
Installation and Configuration
Installation of the adaptor is a simple process. First install the driver, then plug the adaptor into a
USB port. When the adaptor is plugged in, Windows will load the correct drivers for the adaptor
and the new COM port. In this chapter, basic installation and configuration procedures are
explained. Although the installation screens will be for Windows 2000, the procedures are
essentially the same for Windows 98 and later versions.
The following topics are covered in this chapter:
‰ Initial Driver Installation
‰ Hardware Installation
¾ Windows 98/ME and Windows 2000
¾ Windows XP, Windows 2003, and Windows Vista (32-bit and 64-bit)
‰ Configuring the COM Port
‰ Configuring the Adaptor
‰ Removing the Adaptor
‰ Uninstalling the Driver
‰ Install Linux driver for UPort 1100 Series