Mr. Coffee CC12A - Manual (Page 6)

Setting the Clock and Timer (CCX20
only)
IMPORTANT: Please Read Before First Use
The clock on this model must first be set, before the
coffeemaker will operate. -
Hour Set
Minute Set
Brew Set
To Set the Clock...
1. Slide the control switch to OFF.
2. Plug the power cord into your electrical outlet. The clock display will flash
until you set the time.
3. Alternately press and hold the HOUR and MINUTE buttons until you
reach the current time. The PM indicator light in the upper left display
corner will illuminate to indicate PM time.
To Pre-Set the Brewing Time...
Press and hold the BREW button while setting the desired brew time with the
HOUR and MINUTE buttons. The PM INDICATOR light will illuminate to
indicate PM time.
To Automatically Brew at the Pre-Set Time...
1. Follow steps #l through in “BREWING
2. Slide the control switch to OFF and then to AUTO.
3. Brewing will begin at the time you have preset, and the coffee will remain
hot in the decanter for two hours. To keep your coffee hot for an addition-
al two hours, slide the switch from AUTO to ON.
IMPORTANT
,
To Reset Auto Brew at Pre-Set Time.
The programmable timer will NOT automatically brew the next day if left in
the AUTO position after its last use. This Is a safety feature. If the OFF light
in the lower right hand corner of the clock display is illuminated, reset AUTO
BREW by sliding the control switch to OFF and then to AUTO.
6