Makita BO6040 003278 - Manual (Page 9)

9
Installing or removing abrasive disc
CAUTION:
• Always use hook-and-loop system abrasive discs. Never
use pressure-sensitive abrasive discs.
To install the abrasive disc, first remove all dirt or foreign mat-
ter from the pad. Then attach the abrasive disc to the pad,
using the hook-and-loop system of the abrasive disc and the
pad. Be careful to align the holes in the abrasive disc with
those in the pad.
To remove the disc from the pad, just pull up from its edge.
Changing pad
Makita offers an extensive range of optional super soft, soft
and hard pads. Remove the screw counterclockwise from the
center of the base with a hex wrench. After changing the
pad, tighten the screw clockwise securely.
Dust collection (optional accessory)
If a Makita hose is used, you can connect the cuff to the dust
outlet directly.
If other hose with an inner diameter of 24 mm (15/16”),
attach the joint between the dust outlet and the cuff.
1. Abrasive disc
1
003302
1. Screw
2. Hex wrench
3. Pad
1
2
3
003315
1. Dust outlet
2. Cuff
3. Hose
1 2
3
003328
1. Joint
1
003329