Magic Chef MCWC50DST - Manual (Page 8)

OPERATING YOUR APPLIANCE
MCWC50DST: Wine Cooler
• The temperature range of the wine cooler is for 39°F ~
64°F (4°C ~ 18°C) +/- 5°F.
• Temperature
Recommendations:
Red Wine: 54°F ~ 61°F (12°C ~ 16°C)
White Wine: 43°F ~ 50°F (6°C ~ 10°C)
• The display indicates the average temperature of the appliance at the moment.
Pre-Set Wine Zones
• Press the “RED” or “WHITE” pads to choose preset storage conditions for either red or white
wine. (The indicator light “RED” or “WHITE” will illuminate accordingly.)
• The programmed temperature for red or white wine will be displayed for a few seconds.
Manual Temperature Setting
• The temperature of the wine cooler can be set anywhere between 39°F ~ 64°F (4°C ~ 18°C) by
pressing temperature up ▲ and temperature down ▼pads as follows:
1) Press the [SET] pad until you hear a “Beep” sound (approximately 2 seconds).
2) Press
the ▲▼ pads to increase or decrease the desired temperature in increments of
one degree.
3) Press the [SET] pad to confirm your desired temperature setting. If no pad is pressed
within 10 seconds, your select temperature setting will be automatically confirmed.
NOTE:
• To select temperature display between Celsius (°C) or Fahrenheit (°F), press the “▲” pad for
approximately 2 seconds.
MCBC58DST: Beverage Cooler
• The temperature range of the beverage cooler is for 39°F ~
54°F (4°C ~ 12°C). +/- 5°F.
• The display indicates the average temperature of the
appliance at the moment.
NORMAL Temperature Setting
• When the appliance is switched on, or the “NORMAL” pad is pressed, the appliance runs on the
temperature setting of 45°F (7°C) and the “NORMAL” indicator light will be illuminated.
Manual Temperature Setting
• The temperature of the beverage cooler can be set anywhere between 39°F ~ 54°F (4°C ~ 12°C)
by pressing temperature up ▲ and temperature down ▼pads as follows:
1) Press the [SET] pad until you hear a “Beep” sound (approximately 2 seconds).
2) Press
the ▲▼ pads to increase or decrease the desired temperature in increments of
one degree.
3) Press the [SET] pad to confirm your desired temperature setting. If no pad is pressed
within 10 seconds, your select temperature setting will be automatically confirmed.
NOTE:
• The “MANUAL” indicator light will be illuminated while you are manually setting the temperature
on the beverage cooler.
• To select temperature display between Celsius (°C) or Fahrenheit (°F), press the “▲” pad for
approximately 2 seconds.
The following is applicable to both MCWC50DST and MCBC58DST:
• The indicator will remain ON during refrigeration cycle and will be OFF during
idle cycle.
• To switch the Interior light ON/OFF, press the pad.
EN 7