MTD 260 User Manual

Page 13

SECTION 10: MAINTENANCE

WARNING:

Be sure to disconnect and

ground the spark plug wire before
performing any repairs or maintenance.

NOTE:

When tipping the unit, empty the fuel tank

and keep engine spark plug side up.

TROUBLE SHOOTING

Refer to page 16 of this manual for trouble shooting
information.

CUTTING BLADE

When removing the cutting blade for sharpening or
replacement, protect hands by using heavy gloves or
a rag to grasp the cutting blade.

Remove the bolt and bell washer which hold the
blade-pulley assembly to the engine crankshaft.
Remove the assembly from the crankshaft.

Remove the two bolts and lock nuts from the
assembly and remove the blade from the blade
adaptor and pulley.

WARNING:

Periodically inspect the

blade adapter and pulley for cracks,
especially if you strike a foreign object.
Replace when necessary.

When sharpening the blade, follow the original angle
of grind as a guide. It is extremely important that
each cutting edge receives an equal amount of grind-
ing to prevent an unbalanced blade. An unbalanced
blade will cause excessive vibration when rotating at
high speeds, may cause damage to the mower and
could break, causing personal injury.

The blade can be tested by balancing it on a round
shaft screwdriver. Remove metal from the heavy side
until it balances evenly. It is recommended that the
blade always be removed from the adapter for the
best test of balance.

Before reassembling the blade-pulley assembly to
the unit, lubricate the engine crankshaft and the inner
surface of the blade adapter with light oil (or engine
oil). Lubricating the bolt holes, bolts and inner sur-
face of the nuts is also recommended.

Installing the blade

Install the pulley over the blade adapter with the
“star” away from the pulley. Refer to Figure 15.

Place the blade on the adapter with the side of
he blade marked bottom (or with part number)
facing away from the adapter.

Secure the blade to the assembly with two hex
bolts and lock nuts. Tighten the hex bolts to the
torque listed in the “Blade Mounting Torque”
Section below.

Install the blade assembly up on the crankshaft.
Secure with the hex bolt and bell washer
(cupped side of washer to blade) and tighten to
torque listed in the “Blade Mounting Torque”
section below.

Figure 15

Blade Mounting Torque
Blade Adapter Bolts:120 in. lbs. min., 150 in. lbs. max.
Center Bolt: 450 in. lbs. min., 600 in. lbs. max.

To ensure safe operation of your unit, all nuts and
bolts must be checked periodically for correct
tightness.

DECK

The underside of the mower deck should be cleaned
after each use to prevent a buildup of grass
clippings, leaves, dirt or other matter. If this debris is
allowed to accumulate, it will invite rust and
corrosion, and may cause an uneven discharge of
grass clippings at the next cutting.
The deck may be cleaned by tilting the mower and
scraping clean with a suitable tool (make certain the
spark plug wire is disconnected).

ENGINE

Refer to the separate engine manual for engine
maintenance instructions.

Maintain engine oil as instructed in the separate
engine manual packed with your unit. Read and
follow instructions carefully.

Locknut

Pulley

Assembly

Blade

Adapter

Blade

Bell

Washer

Hex Bolt