Philips Magnavox TS2746C1 - Manual (Page 22)

MUTE
CC
A/CH
SLEEP
VOL VOL
CH
CH
MENU
1 2 3
4 5 6
7 8 9
0
STATUS/EXIT POWER
2
4
1
5
7
6
3
8
INPUT ᮣ
SLEEPTIMER OFF
SmartLock ᮣ
CC OFF
SETUP ᮣ
SmartLock
ACCESS CODE
_ _ _ _
SmartLock
ACCESS CODE
X X X X
BLOCK ᮣ
CHANGE CODE ᮣ
CHANNEL 5 BLOCKED
BY CHANNEL BLOCKING
ENTER CODE TO VIEW
_ _ _ _
CHANNEL 5
LOCK NO
CLEAR ALL ᮣ
CHANNEL 5
LOCK YES
CLEAR ALL ᮣ
BLOCKING OPTIONS ᮣ
CHANNELS BLOCKED ᮣ
MOVIE RATINGS ᮣ
U
NDERSTANDING THE
S
MART
L
OCK TM C
ONTROL
(B
LOCK
C
HANNEL
)
A fter your personal access code
has been set (see previous
page), you are now ready to select
the channels you want to block out
or censor.
Press the MENU button on the
remote to show the onscreen menu.
Press the CURSOR UP ▲
or CURSOR DOWN ▼ button
until the words SmartLock are
highlighted.
Press the CURSOR RIGHT
ᮣ button to display the
SmartLock Access screen.
Enter the correct access code
number. “XXXX” shows on the
Access Code display as you press
the NUMBERED buttons.
Press the CURSOR UP ▲ or
DOWN ▼ buttons until the word
BLOCK is highlighted. Press the
CURSOR RIGHT
ᮣ button then
highlight CHANNELS
BLOCKED.
Press the CURSOR RIGHT ᮣ
button. Three options will be dis-
played; CHANNEL, LOCK or
CLEAR ALL.
With CHANNEL highlighted,
use the NUMBERED buttons to
enter the channel number you wish
to block.
Use the CURSOR DOWN ▼
button to highlight the word
LOCK, then press the CURSOR
RIGHT
ᮣ button to select YES
(block) or NO (do not block). The
channel chosen is now blocked from
viewing.
Repeat steps 7 and 8 for any other
channels you wish to block from
viewing.
To clear blocked channels
follow the steps below:
Press the CURSOR DOWN ▼
button until the words CLEAR
ALL are highlighted, then press the
CURSOR RIGHT
ᮣ button.
The screen will read “ALL
UNBLOCKED” for a moment.
At this point ALL the previously
blocked channels will be unblocked.
BEGIN
CHANNEL 5
LOCK YES
CLEAR ALL ᮣ
CHANNEL ALL
LOCK NO
ALL UNBLOCKED
Note: When the CLEAR
ALL option is selected, the
CHANNEL option will dis-
play ALL.
If at this point if you change
the LOCK option to YES,
ALL channels will be blocked
from viewing.
When a blocked channel is viewed, this is what the screen will display. To view the blocked channel,
simply enter the current access code. Note: Once the access code is entered ALL blocked channels will
be viewable until the TV is powered off. Once the set is turned off and then back on the previously
blocked channels will again be blocked.