Channel scan, To turn scan on or off, To respond to scanned channel activity – Motorola GM300 User Manual
Page 2: To delete a nuisance channel, To create or modify the user list, To select priorities for the user list
CHANNEL SCAN
The 8-channel, GM300 mobile may have a single-user scan list which can be programmed from
the front panel.
To turn scan on or off
Press the SCAN (
) button. The radio will only scan when the microphone is on-hook.
The green scan LED will turn on, and display segments will light to indicate that scan is func-
tional. Use the SELECT button to advance through the various scan types:
When an active channel is detected, the channel number will be displayed and you will hear the
call. To leave scan, press the SCAN (
) button.
To respond to scanned channel activity
When the microphone is lifted off-hook, the radio will suspend scanning and return to the chan-
nel displayed before entering scan. If you wish to transmit on another channel, press the
UP/DOWN (
/
) button to reach the desired channel. Scan will resume after replacing the
microphone on-hook.
When scanning with priority, the green scan LED will flash to indicate activity on Priority One
and light steady for Priority Two.
To delete a nuisance channel
While receiving an undesired transmission, hold down the SELECT (
) button for two seconds
and the nuisance channel will be temporarily deleted (until scan is exited or the radio is turned
off). Priority channels and the home channel cannot be deleted.
To create or modify the user list
Hold the SCAN (
) button for two seconds until you hear a second chirp tone and the channel
number flashes. The displayed channel can be added or deleted from the user list by pressing the
SELECT (
) button.
A vertical segment in the upper left corner of the display will light and
flash, alternating with the channel number to indicate that the flashing
channel has been added to the scan list. The segment will disappear when
the channel is deleted.
Use the UP/DOWN (
/
) and SELECT (
) buttons to add or delete
other desired channels in the user list.
To select priorities for the user list
Go to the desired channel and hold the SELECT (
) button down for two seconds. The scan LED
will flash to indicate that this is the first priority channel. Repeat the process to select a second
priority channel. Priority Two will be indicated by a steady light on the scan LED.
The Priority-One channel must be programmed first, followed by the Priority-Two channel.
Deleting either of the priority channels will delete both channels simultaneously.
User Scan
Priority User Scan
+
+
+
+
, Motorola, MaxTrac, PL, and DPL
are trademarks of Motorola, Inc.
© 1997 by Motorola, Inc.
8000 West Sunrise Blvd.
Ft. Lauderdale, FL 33322
Printed in U.S.A.
All Rights Reserved.